Agilent Technologies X Series Manual page 559

Couplings
Preset
State Saved
Min
Max
Initial S/W Revision
Gate Delay Compensation
This function allows you to select an RBW-dependent value by which to adjust the gate delay, to
compensate for changes in the delay caused by RBW effects.
You can select between uncompensated operation and two types of compensation,
Settled and Compensate for RBW Group Delay
See "More Information" on page 560
Key Path
Scope
Remote Command
Example
When is
Gate Holdoff Auto
by the analyzer for the wait time.
Pressing the
Gate Holdoff
key to become selected and allows the user to adjust the value. If the value is
adjusted, the setting changes to
Pressing the
Gate Holdoff
change the value of
Gate Holdoff
Now the user can adjust the value.
Pressing the key while it is in
back to Auto .
Pressing the key while it is in
selected and allows the user to adjust the value.
When is set to
Method Video
Auto
Auto/On
Saved in instrument state
1 μsec
1 sec
Prior to A.02.00
.
Sweep/Control, Gate
Meas Global
[:SENSe]:SWEep:EGATe:DELay:COMPensation:TYPE
OFF|SETTled|GDELay
[:SENSe]:SWEep:EGATe:DELay:COMPensation:TYPE?
SWE:EGAT:DEL:COMP:TYPE SETT
SWE:EGAT:DEL:COMP:TYPE?
, the key shows the value calculated
Gate Holdoff
key while it is in and not selected, causes the
Auto
.
Man
key, while it is in and selected, does not
Auto
, but causes the setting to change to
and selected, cause the value to change
Man
Man and not selected, causes the key to become
or , the
FFT Gate Holdoff
Sweep/Control
Man.
function has no effect.
Delay Until RBW
559