Agilent Technologies X Series Manual page 459

Example
Preset
State Saved
Initial S/W Revision
Sweeping (HSWP)
Selects the Sweeping Trigger signal to be output to the Trig 1 Out or Trig 2 Out connector when a
measurement is made. This signal has historically been known as "HSWP" (High = Sweeping), and is 5
V TTL level with 50 ohm output impedance."
Key Path
Example
Readback
Initial S/W Revision
Measuring
Selects the Measuring trigger signal to be output to the Trig 1 Out or Trig 2 Out connector. This signal is
true while the Measuring status bit is true.
Key Path
Example
Readback
Initial S/W Revision
Main Trigger
Selects the current instrument trigger signal to be output to the Trig 1 Out or Trig 2 Out connector.
Key Path
Example
Readback
Initial S/W Revision
Gate Trigger
Selects the gate trigger signal to be output to the Trig 1 Out or Trig 2 Out connector. This is the source of
the gate timing, not the actual gate signal.
TRIG1:OUTP:POL POS
This is unaffected by a Preset but is set to POSitive on a "Restore Input/Output
Defaults" or "Restore System Defaults->All"
Saved in instrument state
Prior to A.02.00
Input/Output, Output Config, Trig 1/2 Output
TRIG1:OUTP HSWP
Sweeping
Prior to A.02.00
Input/Output, Output Config, Trig 1/2 Output
TRIG1:OUTP MEAS
Measuring
Prior to A.02.00
Input/Output, Output Config, Trig 1/2 Output
TRIG1:OUTP MAIN
Main Trigger
Prior to A.02.00
Input/Output
459