Agilent Technologies X Series Manual page 437

Preset
State Saved
Readback
Backwards Compatibility SCPI
Initial S/W Revision
Inputs
Sets the measurement to use the input selections (RF, AREF, I/Q)
Key Path
Example
Notes
Readback
Initial S/W Revision
Capture Buffer
Some WCDMA and demod measurements support this feature. This allows sharing of the raw data
across certain measurements. If you want to make another measurement on the same signal, you would
store that raw data using the "Current Meas -> Capture Buffer" key. Then the data is available for the
next measurement to use. You must have raw data stored in the instrument memory before the Capture
Buffer choice is available for use.
Key Path
Example
Notes
Dependencies
Readback
Initial S/W Revision
This is unaffected by Preset but is set to INPut on a "Restore Input/Output
Defaults" or "Restore System Defaults->All"
Saved in instrument state
Variable
[:SENSe]:FEED:SOURce INPut|STORed
[:SENSe]:FEED:SOURce?
Prior to A.02.00
Input/Output, Data Source
FEED:DATA INP causes the measurement to look at the input selection
Does not auto return.
Inputs
Prior to A.02.00
Input/Output, Data Source
FEED:DATA STOR causes stored measurement data to be used with a
different measurement that supports this.
Does not auto return. This key is grayed out when you switch to a
measurement that does not support this feature.
If you switch to a measurement that does not support this feature, then the
instrument switches to use "Inputs" and grays out this key. If the grayed out
key is pressed, it generates a message.
Stored Data
Prior to A.02.00
Input/Output
437