Coolant Check; Coolant Replacement - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:13:46 61TA0000_100_0006

Cooling System

Coolant Check

1. Check the coolant level in the coolant reservoir.

Make sure it is between the MAX mark (A) and MIN

2. If the coolant level in the coolant reservoir is at or

below the MIN mark, add coolant to bring it up to

the MAX mark, then inspect the cooling system for

ＴＡ０８ＡＥ４Ａ１４４０００１７３０１ＭＡＡＴ０１

1. Remove the radiator cap.

2. Start the engine. Set the heater temperature control

dial to maximum heat, then turn the ignition switch

to LOCK (0). Make sure the engine and radiator are

cool to the touch.

3. Loosen the drain plug (A), and drain the coolant.

4. After the coolant has drained, tighten the radiator

drain plug securely.

5. Remove, drain, and reinstall the coolant reservoir.

6. Fill the coolant reservoir to the MAX mark (A) with

Honda Long Life Antifreeze/Coolant Type 2

(P/N OL999-9011).

ＴＡ０８ＡＥ４Ａ１４４０００１７３０１ＫＢＡＴ０２

Table of Contents