Honda Accord 2008 Manual page 280

07/11/02 09:11:26 61TA0000_080_0019
4. Remove the upper balancer shaft holder (with
bearings) (A) and baffle plates (B), then remove the
front balancer shaft (C) and the rear balancer shaft
(D).
＊１３
5. Measure the diameter of the No. 1 journal on the
rear balancer shaft.
Journal Diameter
Standard (New): 23.938 23.950 mm
Service Limit:
＊１４
B
C
−
−
(0.9424 0.9429 in.)
23.92 mm (0.942 in.)
6. Measure the inner diameter of the No. 2 bearing for
the front balancer shaft hole and the rear balancer
shaft hole.
Bearing Inner Diameter
Front:
Standard (New): 20.000 20.020 mm
Service Limit:
Rear:
Standard (New): 24.000 24.020 mm
A
Service Limit:
Front
D
Rear
−
(0.7874 0.7882 in.) −
20.03 mm (0.798 in.)
−
(0.9449 0.9457 in.) −
24.03 mm (0.946 in.)
(cont'd)
8-19
＊１５
＊１６