Honda Accord 2008 Manual page 306

07/11/02 09:13:49 61TA0000_100_0011
14. Install the water pump (see page 10-5).
15. Install the thermostat housing (A) with a new O-ring
(B).
＊０４
16. Clean and dry the water passage mating surfaces.
17. Apply liquid gasket, P/N 08717-0004, 08718-0001,
08718-0003, or 08718-0009, evenly to the engine
block mating surface of the water passage. Install
the component within 5 minutes of applying the
liquid gasket.
NOTE:
• If you apply liquid gasket P/N 08718-0012, the
component must be installed within 4 minutes.
• If too much time has passed after applying the
liquid gasket, remove the old liquid gasket and
residue, then reapply new liquid gasket.
＊０５
Apply liquid gasket
along the broken line.
B
Replace.
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
A
18. Install the water passage (A) with a new O-ring (B).
NOTE:
• Wait at least 30 minutes before filling the engine
with coolant.
• Do not run the engine for at least 3 hours after
installing the water passage.
A
10 x 1.25 mm
44 N·m (4.5 kgf·m, 33 lbf·ft)
19. Install the water bypass hose (A) and the PCV hose
(B).
E
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
A
B D C
Replace.
20. Install the connecting pipe (C) with a new O-ring (D),
then tighten the connecting pipe mounting bolts (E)
securing the connecting pipe.
＊０６
B
Replace.
＊０７
(cont'd)
10-11