Cylinder Head Cover Installation - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:25:03 61TA0000_060_0077

Cylinder Head Cover Installation

1. Thoroughly clean the head cover gasket and the

2. Install the head cover gasket (A) in the groove of

the cylinder head cover (B).

3. Check that the mating surfaces are clean and dry.

4. Apply liquid gasket, P/N 08717-0004, 08718-0001,

08718-0003, or 08718-0009, on the chain case and

the No. 5 rocker shaft holder mating areas. Install

the component within 5 minutes of applying the

liquid gasket.

• If you apply liquid gasket P/N 08718-0012, the

component must be installed within 4 minutes.

• If too much time has passed after applying the

liquid gasket, remove the old liquid gasket and

residue, then reapply new liquid gasket.

Apply liquid gasket

to these points.

Apply liquid gasket

to these points.

5. Set the spark plug seals (A) on the spark plug tubes.

Place the cylinder head cover (B) on the cylinder

head, then slide the cover slightly back and forth to

seat the head cover gasket.

6. Inspect the cover washers (C). Replace any washer

that is damaged or deteriorated.

7. Tighten the bolts in three steps. In the final step

tighten all bolts, in sequence, to 12 N·m (1.2 kgf·m,

8.7 lbf·ft).

• Wait at least 30 minutes before filling the engine

• Do not run the engine for at least 3 hours after

installing the head cover.

ＴＡ０８ＡＥＪＡ１４６０００１７８１１ＫＣＡＴ００

Table of Contents