Honda Accord 2008 Manual page 87

07/11/02 09:06:07 61TA0000_040_0041
Charging System
Alternator Overhaul (cont'd)
Alternator Reassembly
16. If you removed the pulley, put the rotor in the drive
end housing, then tighten its locknut to 110 N·m
(11.2 kgf·m, 81.0 lbf·ft).
17. Remove any grease or oil from the slip rings.
18. Put the rear housing assembly and drive end
housing/rotor assembly together, and tighten the
four through bolts.
19. Push the brushes (A) in, then insert a pin or drill bit
(B) (about 1.6 mm (0.06 in.) diameter) to hold them
there.
＊１３
20. Install the brush holder, and pull out the pin or drill
bit.
＊１４
21. Install the end cover.
22. After assembling the alternator, turn the pulley by
hand to make sure the rotor turns smoothly and
without noise.
23. Install the alternator (see page 4-34) and drive belt
(see page 4-31).
4-40
A
B