Rocker Arm Assembly Installation - Honda Accord 2008 Manual

07/11/02 09:23:54 61TA0000_060_0045

Rocker Arm Assembly Installation

1. Reassemble the rocker arm assembly (see page
6-34).
2. Clean and dry the No. 5 rocker shaft holder mating
surface.
3. Apply liquid gasket, P/N 08717-0004, 08718-0001,
08718-0003, or 08718-0009, evenly to the cylinder
head mating surface of the No. 5 rocker shaft
holder. Install the component within 5 minutes of
applying the liquid gasket.
NOTE:
• If you apply liquid gasket P/N 08718-0012, the
component must be installed within 4 minutes.
• If too much time has passed after applying the
liquid gasket, remove the old liquid gasket and
residue, then reapply new liquid gasket.
＊０１
4. Insert the bolts (A) into the rocker shaft holder, then
install the rocker arm assembly (B) on the cylinder
head.
＊０２
5. Remove the bolts from the rocker shaft holder.
Apply liquid gasket
along the broken line.
A
A
6. Make sure the punch marks on the variable valve
timing control (VTC) actuator and the exhaust
camshaft sprocket are facing up, then set the
camshafts (A) in the holder.
B
A
7. Set the camshaft holders (B) and cam chain guide B
(C) in place.
8. Tighten the bolts to the specified torque.
NOTE: If the engine does not have bolt
and continue the torque sequence.
Specified Torque
8 x 1.25 mm
22 N·m (2.2 kgf·m, 16 lbf·ft)
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
6 x 1.0 mm Bolts:
B
9. Install the cam chain (see page 6-15), then adjust
the valve clearance (see page 6-9).
ＴＡ０８ＡＥＩＡ１４６６６３０００００ＫＣＡＴ００
C
, skip it
, ,
6-45
＊０３
＊０４