Honda Accord 2008 Manual page 144

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:23:01 61TA0000_060_0021

Installation

1. Install the auto-tensioner.

NOTE: Check the auto-tensioner cam position. If the

position are not aligned, set the first cam to the first

edge of the rack.

2. Remove the pin or lock pin (P/N 14511-PNA-003)

from the auto-tensioner.

3. Remove the old liquid gasket from the chain case

cover mating surfaces, the bolts, and the bolt holes.

4. Clean and dry the chain case cover mating surfaces.

12 N·m (1.2 kgf·m, 8.7 lbf·ft)

5. Apply liquid gasket, P/N 08717-0004, 08718-0001,

08718-0003, or 08718-0009, evenly to the chain

case mating surface of the chain case cover. Install

the component within 5 minutes of applying the

liquid gasket.

• If you apply liquid gasket P/N 08718-0012, the

component must be installed within 4 minutes.

• If too much time has passed after applying the

liquid gasket, remove the old liquid gasket and

residue, then reapply new liquid gasket.

6. Install the chain case cover.

• Wait at least 30 minutes before filling the engine

• Do not run the engine for at least 3 hours after

installing the chain case cover.

Apply liquid gasket

along the broken line.

(1.2 kgf·m, 8.7 lbf·ft)

Chapters

Table of Contents