Honda Accord 2008 Manual page 86

07/11/02 09:05:36 61TA0000_040_0040
12. Install a new front bearing in the driver-end
housing with a hammer, the handle driver, and the
attachment.
＊１０
Alternator Brush Inspection
13. Measure the length of both brushes (A) with a
vernier caliper (B).
• If either brush is shorter than the service limit,
replace the brush holder assembly.
• If brush length is OK, go to step 14.
Alternator Brush Length
Standard (New): 10.5 mm (0.41 in.)
Service Limit:
＊１１
07749-0010000
07746-0010300
1.5 mm (0.06 in.)
B
Rotor Slip Ring Test
14. Check for continuity between the slip rings (A).
• If there is continuity, go to step 15.
• If there is no continuity, replace the rotor
assembly.
A
15. Check for continuity between each slip ring and the
rotor (B) and the rotor shaft (C).
• If there is no continuity, replace the rear housing
assembly, and go to step 16.
• If there is continuity, replace the rotor assembly.
A
C
B
(cont'd)
4-39
＊１２