Valve, Spring, And Valve Seal Installation - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:23:53 61TA0000_060_0044

Cylinder Head

Valve, Spring, and Valve Seal Installation

Special Tools Required

• Stem seal driver 07PAD-0010000

• Valve spring compressor attachment 07757-PJ1010A

1. Coat the valve stems with new engine oil. Install

the valves in the valve guides.

2. Check that the valves move up and down smoothly.

3. Install the spring seats on the cylinder head.

4. Install the new valve seals (A) using the stem seal

NOTE: The exhaust valve seal (C) has a black spring

(D), and the intake valve seal (E) has a white spring

(F). They are not interchangeable.

07PAD-0010000

NOTE: Use the 5.5 mm side.

5. Install the valve spring and the spring retainer.

Place the end of the valve spring with the closely

wound coils toward the cylinder head.

6. Install the valve spring compressor and the

attachment. Compress the spring, and install the

valve cotters.

07757-PJ1010A

7. Remove the valve spring compressor and the

8. Lightly tap the end of each valve stem two or three

times with a plastic mallet (A) to ensure proper

seating of the valve and the valve cotters. Tap the

valve stem only along its axis so you do not bend

ＴＡ０８ＡＥＩＡ１４６８０２０００００ＫＣＡＴ００

Table of Contents