Honda Accord 2008 Manual page 98

07/11/02 09:06:13 61TA0000_040_0052
9. Measure the voltage between engine mount
control solenoid valve 2P connector terminals No. 1
and No. 2 with the engine at idle.
＊０２
Is there battery voltage?
YES
NO −
(C40) and the engine mount control solenoid valve
2P connector. If the wire is OK, update the ECM/
PCM if it does not have the latest software
(see page 11-231), or substitute a known-good
ECM/PCM (see page 11-7), and recheck. If the
engine mount control system works properly, and
the ECM/PCM was updated, the troubleshooting is
complete. If the ECM/PCM was substituted, replace
the original ECM/PCM (see page 11-232).
ENGINE MOUNT CONTROL
SOLENOID VALVE 2P CONNECTOR
MCS IG1
(BLU/YEL) (BLK/YEL)
Wire side of female terminals
−
Go to step 10.
Repair open in the wire between ECM/PCM
10. Raise the engine speed above 1,000 rpm.
11. Measure the voltage between engine mount
control solenoid valve 2P connector terminals No. 1
and No. 2.
ENGINE MOUNT CONTROL
SOLENOID VALVE 2P CONNECTOR
MCS IG1
(BLU/YEL) (BLK/YEL)
Wire side of female terminals
Is there battery voltage?
YES − Repair short to body ground in the wire
between ECM/PCM (C40) and the engine mount
control solenoid valve. If the wire is OK, update the
ECM/PCM if it does not have the latest software
(see page 11-231), or substitute a known-good
ECM/PCM (see page 11-7), and recheck. If the
engine mount control system works properly, and
the ECM/PCM was updated, the troubleshooting is
complete. If the ECM/PCM was substituted, replace
the original ECM/PCM (see page 11-232).
−
NO Go to step 12.
12. Turn the ignition switch to LOCK (0).
＊０３
(cont'd)
4-51