Honda Accord 2008 Manual page 62

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:04:53 61TA0000_040_0016

7. Check the mica depth (A). If the mica is too high (B),

undercut the mica with a hacksaw blade to the

proper depth. Cut away all the mica (C) between

the commutator segments. The undercut should

not be too shallow, too narrow, or V-shaped (D).

Commutator Mica Depth

Standard (New): 0.40 0.50 mm (0.016 0.020 in.)

Service Limit:

8. Check for continuity between the segments of the

commutator. If there is an open circuit between any

of the segments, replace the armature.

0.15 mm (0.006 in.)

9. Place the armature (A) on an armature tester (B).

Hold a hacksaw blade (C) on the armature core. If

the blade is attracted to the core or vibrates while

the core is turned, the armature is shorted. Replace

the armature.

10. Check with an ohmmeter for continuity between

the commutator (A) and armature coil core (B), and

between the commutator and armature shaft (C). If

there is continuity, replace the armature.

Chapters

Table of Contents