Honda Accord 2008 Manual page 114

07/11/02 09:07:45 61TA0000_050_0015
12. Raise the vehicle on the lift.
13. Using the front subframe adapter (VSB02C000016)
and a jack, raise the subframe up to body.
＊０９
D
A
B
12 x 1.25 mm
54 N·m
(5.5 kgf·m,
40 lbf·ft)
14. Loosely install the new front subframe mounting
bolts (four) (A), the stiffener mounting bolts (four)
(B) (C), and the stiffeners (four) (D).
15. Loosely install the subframe middle mount.
＊１０
16. Remove the jack and the front subframe adapter.
VSB02C000016
D
B
D C
A
A
C
12 x 1.25 mm 14 x 1.5 mm
93 N·m 103 N·m
(9.5 kgf·m, 69 lbf·ft) (10.5 kgf·m, 75.9 lbf·ft)
Replace. Replace.
17. Insert the frame positioning guide pin (070AG-
SJAA10S) through the positioning slot (A) on the
right rear stiffener, through the positioning hole (B)
on the subframe, and into the positioning hole (C)
on the body, then loosely tighten the subframe
right rear mounting bolt.
070AG-SJAA10S
NOTE: Use 15.7 mm side.
18. Insert the frame positioning guide pin through the
positioning slot on the left rear stiffener, through
the positioning hole on the subframe, and into the
positioning hole on the body, then loosely tighten
the subframe left rear mounting bolt.
19. With the frame positioning guide pin in place,
tighten the subframe right rear mounting bolt.
20. With the frame positioning guide pin in place,
tighten the subframe left rear mounting bolt.
21. Tighten the stiffener mounting bolts to the
specified torque.
22. Tighten the subframe mounting bolts to the
specified torque.
23. Check that the positioning slots on the right/left
rear stiffener, the positioning holes on the
subframe, and the positioning holes on the body
are aligned using the frame positioning guide pin.
＊１１
C
B
A
(cont'd)
5-15