Honda Accord 2008 Manual page 90

07/11/02 09:06:10 61TA0000_040_0044
Symptom
Set speed will not
resume when the
resume/accel switch is
pressed (with the cruise
control main switch
turned on, and set speed
temporarily canceled by
pressing the brake pedal)
Set speed will not
resume when the
resume/accel switch is
pressed (with the cruise
control main switch
turned on, and set speed
temporarily canceled by
pressing the clutch pedal)
(M/T model)
With the ignition switch
in ON (II), and the lighting
switch turned on, the
cruise control
combination switch
illumination does not
come on
Diagnostic procedure
1. Check for PGM-FI DTCs (see page 11-3).
2. Check the brake pedal position switch adjustment
(see page 19-6).
3. Do the cruise control combination switch test (see page
4-47).
4. Do the cruise control input test (see page 4-45).
Test the cruise control resume/accel switch signal input.
Test the brake pedal position switch signal input.
1. Check for PGM-FI DTCs (see page 11-3).
2. Check the clutch pedal position switch adjustment
(see page 12-7).
3. Do the cruise control combination switch test (see page
4-47).
4. Do the cruise control input test (see page 4-45).
Test the resume/accel switch signal input.
Test the clutch pedal position switch signal input.
Check the cruise control combination switch test (see page
4-47).
Also check for
• Faulty brake pedal
position switch
• Open circuit, loose or
disconnected
terminals: LT BLU,
GRY wire
• Open circuit, loose or
disconnected
terminals:
LT BLU, GRY wire
• Faulty clutch pedal
position switch
4-43