Honda Accord 2008 Manual page 121

07/11/02 09:08:02 61TA0000_050_0022
Engine Assembly
Engine Installation (cont'd)
61. Connect the battery cables (A) to the under-hood
fuse/relay box.
＊３４
62. Connect the harness connector (B), and install the
harness connector to the bracket (C).
63. Install the water separator (see step 10 on page 9-7).
64. Install the battery base (A), then install the harness
clamps (B).
＊３５
B
65. Install the air cleaner assembly (see page 11-385).
66. Install the strut brace (if equipped) (see page
20-287).
67. Install the front grille cover:
• 2-door (see page 20-255)
• 4-door (see page 20-255)
5-22
C
A
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
68. Do the battery installation procedure (see page
22-90).
69. A/T model: Move the shift lever to each gear, and
verify that the A/T gear position indicator follows
the transmission range switch.
70. M/T model: Check that the transmission shifts into
all gears smoothly.
71. Inspect for fuel leaks. Turn the ignition switch to
ON (II) (do not operate the starter) so the fuel pump
runs for about 2 seconds and pressurizes the fuel
line. Repeat this operation three times, then check
B
for fuel leakage at any point in the fuel line.
72. Refill the engine with engine oil (see step 4 on page
8-10).
73. Refill the transmission with fluid:
• Manual transmission (see page 13-5)
• Automatic transmission (see page 14-242)
74. Refill the radiator with engine coolant, and bleed
air from the cooling system with the heater valve
open (see step 6 on page 10-6).
75. Do the ECM/PCM reset procedure (see page 11-4).
A
76. Do the ECM/PCM idle learn procedure (see page
11-343).
77. Do the crankshaft position (CKP) pattern clear/CKP
pattern learn procedure (see page 11-5).
78. Inspect the idle speed (see page 11-342).
79. Inspect the ignition timing (see page 4-20).
80. Check the wheel alignment (see page 18-5).