Honda Accord 2008 Manual page 102

07/11/02 09:07:37 61TA0000_050_0003
Engine Removal
Special Tools Required
• Universal eyelet 07AAK-SNAA120
• Engine hanger adapter VSB02C000015
• Front subframe adapter VSB02C000016
• Engine support hanger, A and Reds AAR-T1256
: These special tools are available through the Honda
Tool and Equipment Program, 1-888-424-6857
NOTE:
• Use fender covers to avoid damaging painted
surfaces.
• To avoid damaging the wiring and terminals, unplug
the wiring connectors carefully while holding the
connector portion.
• Mark all wiring and hoses to avoid misconnection.
Also, be sure that they do not contact other wiring or
hoses, or interfere with other parts.
1. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
＊０１
2. Remove the front grille cover:
• 2-door (see page 20-255)
• 4-door (see page 20-255)
3. Remove the strut brace (if equipped) (see page
20-287).
4. Relieve the fuel pressure (see page 11-358).
5. Do the battery removal procedure (see page 22-90).
6. Remove the air cleaner assembly (see page 11-385).
7. Remove the harness clamps (A), then remove the
battery base (B).
A
8. Remove the water separator (see step 3 on page
9-3).
9. Disconnect the battery cables (A) from the under-
hood fuse/relay box.
C
A
10. Disconnect the harness connector (B), and remove
the harness connector from the bracket (C).
ＴＡ０８ＡＥ４Ａ１８２２３８０００００ＫＡＡＴ００
＊０２
B
＊０３
B
(cont'd)
5-3