Re-S-X6-128G Routing Engine Leds; Figure 29: Re-S-X6-128G Routing Engine Leds; Table 22: Re-S-X6-128G Routing Engine Leds - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide

Table 22: RE-S-X6-128G Routing Engine LEDs

Label Color
Green
ONLINE
-
68
to a management network, and two asynchronous serial ports—one for connecting to
a console and one for connecting to a modem or other auxiliary device.
button—Reboots the Routing Engine when pressed.
RESET
ONLINE/OFFLINE button—Brings the Routing Engine online or takes it offline when
pressed.
NOTE: The
ONLINE/OFFLINE
seconds for the power off or power on to occur.
Extractor clips—Control the locking system that secures the Routing Engine.
LEDs—Table 22 on page 68
NOTE: For specific information about Routing Engine components (for
example, the amount of DRAM), issue the

RE-S-X6-128G Routing Engine LEDs

Each Routing Engine has five LEDs that indicate its status. The LEDs—labeled
DISK1 , DISK2 , ONLINE , and
Table 22 on page 68 describes the functions of the Routing Engine LEDs.

Figure 29: RE-S-X6-128G Routing Engine LEDs

1— ONLINE
LED
2— OK/FAIL
LED
3— DISK1
LED
State
Blinking slowly
Blinking rapidly
Off
button must be pressed for a minimum of 4
describes the functions of these LEDs.
OK/FAIL —are located on the faceplate of the Routing Engine.
4— DISK2
5— ONLINE/OFFLINE
6— MASTER
Description
Routing Engine is in the process of booting BIOS, and the host
OS.
Routing Engine is in the process of booting Junos OS.
Routing Engine is not online or not functioning normally.
command.
show vmhost hardware
MASTER
LED
button
LED
Copyright © 2019, Juniper Networks, Inc.
,