Replacing A T320 Air Filter - Juniper T320 Replacing Manual

Replacing a T320 Air Filter

Figure 4: Installing a Rear T320 Fan Tray
Removing a Front T320 Air Filter on page 5
Installing a Front T320 Air Filter on page 6
Removing a Rear T320 Air Filter on page 7
Installing a Rear T320 Air Filter on page 9
Removing a Front T320 Air Filter
The front air filter, located below the FPC card cage in the front of the chassis, and
installs horizontally. The front air filter weighs approximately 1 lb (0.5 kg).The air
filters are hot-insertable and hot-removable.
To remove the front air filter (see Figure 5):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to one of the ESD points on the chassis.
Unwrap any PIC cables from the spools on the cable management system, and
2.
remove the cables from the tray. Arrange the cables so that they do not block
the front of the cable management system and tray, and secure them with
Replacing a T320 Air Filter
5