Installing The Mx2020 Dc Cable Manager; Replacing Mx2020 Emi Covers; Removing Mx2020 Emi Covers; Figure 147: Installing The Dc Cable Manager - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide

Installing the MX2020 DC Cable Manager

Related
Documentation

Replacing MX2020 EMI Covers

Removing MX2020 EMI Covers

310
To install the DC cable manager (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Position the DC cable manager over the two slots located on both sides of the DC
2.
PDM.
Lift the DC cable manager slightly up while inserting the two flanges into the slots on
3.
both sides of the DC PDM.
Push down to secure the DC cable manager in place.
4.

Figure 147: Installing the DC Cable Manager

D
Preventing Electrostatic Discharge Damage to an MX2020 Router on page 320
MX2020 Cable Manager Description on page 58
Removing MX2020 EMI Covers on page 310
1.
Installing MX2020 EMI Covers on page 311
2.
To remove the electromagnetic interference (EMI) card cage cover (see
page 311).
Loosen the four captive screws that secure the EMI cover to the router.
1.
Pull the cover away from the router toward you to remove it.
2.
Figure 147 on page 310):
Copyright © 2013, Juniper Networks, Inc.
Figure 148 on