MX2020 3D Universal Edge Router Hardware Guide
Installing the MX2020 Extended DC Cable Manager
448
Figure 201: Installing the Extended Lower Cable Manager
To install the extended DC cable manager (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Position the extended DC cable manager over the two slots located on both sides of
2.
the DC PDM.
Lift the extended DC cable manager slightly up while inserting the two flanges into
3.
the slots on both sides of the DC PDM.
Push the extended DC cable manager into place.
4.
Tighten the two captive screws to secure the extended DC cable manager.
5.
Figure 202 on page
449):
Copyright © 2015, Juniper Networks, Inc.