Tools And Parts Required To Connect The T4000 Router To External Devices; Connecting The T4000 Router To A Management Console Or Auxiliary Device - Juniper T4000 Hardware Manual
Core router
Hide thumbs
Also See for T4000:
- Datasheet (4 pages) ,
- Hardware manual (396 pages) ,
- Quick start manual (40 pages)
Table of Contents
Advertisement
T4000 Core Router Hardware Guide
Related
Documentation
Tools and Parts Required to Connect the T4000 Router to External Devices
Related
Documentation
Connecting the T4000 Router to a Management Console or Auxiliary Device
178
NOTE:
The external clock inputs on the SCG with DB-9 ports are not
supported.
A network connection to the ports on the PICs.
See
"Connecting PIC Cables to the T4000 Router" on page
Overview of Installing the T4000 Router on page 119
To connect the router to external devices, you need the following tools:
Phillips (+) screwdrivers, numbers 1 and 2
2.5-mm flat-blade (-) screwdriver
Electrostatic discharge (ESD) grounding wrist strap
Overview of Connecting the T4000 Router to External Devices on page 177
Connecting the T4000 Router to a Management Console or Auxiliary Device on page 178
Connecting the T4000 Router to an External Alarm-Reporting Device on page 182
Connecting the T4000 Router to an External Clocking Device
Connecting PIC Cables to the T4000 Router on page 183
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate
port on the CIP. To use a laptop, modem, or other auxiliary device,
CONSOLE
connect it to the appropriate
(EIA-232) serial cable with a DB-9 female connector. One DB-9/DB-9 cable is provided
with the router. To connect a device to the
port, you must supply another cable.
AUXILIARY
To connect a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Connect one end (shown in
3.
connector to the appropriate
The ports labeled
HOST 0
port on the CIP. Both ports accept an RS-232
AUXILIARY
CONSOLE
port, and another device to the
Figure 63 on page
179) of a serial cable with a DB-9 female
CONSOLE
or
AUXILIARY
connect to the Routing Engine in the upper Routing Engine
Copyright © 2018, Juniper Networks, Inc.
183.
port (see
Figure 64 on page
180).
Advertisement
Table of Contents
Troubleshooting
