Connecting The Router To A Management Console Or Auxiliary Device - Juniper ACX4000 Hardware Manual

3. Plug the other end of the cable into the network device.
Figure 21: Ethernet Cable Connector
Figure 22: Ethernet Port

Connecting the Router to a Management Console or Auxiliary Device

You can connect a console, laptop, modem, or other auxiliary device by connecting a serial cable to the
port on the front panel labeled CONSOLE/AUX. This port accepts a serial cable with an RJ-45 connector
that is provided with the router.
To connect a management console or auxiliary device:
1. Turn off the power to the console or auxiliary device.
2. Plug the RJ-45 end of the serial cable into the AUX port or CONSOLE port on the front panel
23 on page 109 shows the connector.
3. Plug the DB-9 socket end into the device's serial port.
NOTE: For console devices, configure the serial port to the following values:
• Baud rate—9600
• Parity—N
• Data bits—8
Figure 24 on page 109 shows the ports.)
108
(Figure