Connecting Mx5, Mx10, Mx40, And Mx80 Routers To Management Devices; Connecting The Router To A Network For Out-Of-Band Management; Connecting The Router To A Management Console Or Auxiliary Device; Figure 35: Routing Engine Ethernet Cable Connector - Juniper MX5 Hardware Manual

See Also

Connecting MX5, MX10, MX40, and MX80 Routers to Management Devices

Connecting the Router to a Network for Out-of-Band Management

Connecting the Router to a Management Console or Auxiliary Device

Copyright © 2019, Juniper Networks, Inc.
request system halt
Connecting the Router to a Network for Out-of-Band Management on page 91
Connecting the Router to a Management Console or Auxiliary Device on page 91
To connect to the
ETHERNET
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable
2.
the ETHERNET port on the Routing Engine.
Plug the other end of the cable into the network device.
3.

Figure 35: Routing Engine Ethernet Cable Connector

Figure 36: Ethernet Port

Alarm Routing Console
LEDs Engine port
LED
System
status
LED
ONLINE/
OFFLINE
ONLINE/ Reset Auxiliary USB
OFFLINE port port
button
button
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate port on the front panel. To use a laptop, modem, or other auxiliary
CONSOLE
device, connect it to the AUX
RJ-45 connector. One serial cable with an RJ-45 connector and a DB-9 connector is
provided with the router. To connect a device to the
to the port, you must supply an additional cable.
AUX
To connect a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
Chapter 3: Initial Installation and Configuration
port on the Routing Engine:
(Figure 35 on page 91
Figure 36 on page 91
Ethernet
port
Clock
ports 10-Gigabit Ethernet MIC
port on the front panel. Both ports accept a cable with an
CONSOLE
shows the connector) into
shows the port.
port and another device
91