ACX2200 Universal Access Router Hardware Guide
Connecting the Router to a Management Console or Auxiliary Device
80
Figure 21: Ethernet Port
CONSOLE/AUX
port
You can connect a console, laptop, modem, or other auxiliary device by connecting a
serial cable to the port on the front panel labeled
serial cable with an RJ-45 connector, which is provided with the router.
To connect a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
Plug the RJ-45 end of the serial cable into the
2.
(Figure 22 on page 80
shows the connector.
Plug the female DB-9 end into the device's serial port.
3.
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Figure 22: Routing Engine Console and Auxiliary Cable Connector
Figure 23: Auxiliary and Console Connections
CONSOLE/AUX
port
Console Server
CONSOLE/AUX
CONSOLE/AUX
Figure 23 on page 80
Console Server
PC
. This port accepts a
port on the front panel
shows the ports.)
PC
Copyright © 2017, Juniper Networks, Inc.