ACX1000 and ACX1100 Universal Access Router Hardware Guide
Connecting the Router to a Management Console or Auxiliary Device
96
Figure 25: Ethernet Port
CONSOLE/AUX
port
You can connect a console, laptop, modem, or other auxiliary device by connecting a
serial cable to the port on the front panel labeled
serial cable with an RJ-45 connector, which is provided with the router.
To connect a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
Plug the RJ-45 end of the serial cable into the
2.
panel
(Figure 26 on page 96
ports.)
Plug the female DB-9 end into the device's serial port.
3.
NOTE:
For console devices, configure the serial port to the following values:
Bits per second—9600
Data bits—8
Parity—None
Stop bits—1
Flow control—None
Figure 26: Routing Engine Console and Auxiliary Cable Connector
Figure 27: Auxiliary and Console Connections
CONSOLE/AUX
port
Console Server
CONSOLE/AUX
port or
AUX
shows the connector.
Figure 27 on page 96
Console Server
PC
. This port accepts a
port on the front
CONSOLE
shows the
PC
Copyright © 2017, Juniper Networks, Inc.