Ptx1000 Installation Safety Guidelines; General Installation Safety Guidelines; Ptx1000 Chassis Lifting Guidelines - Juniper PTX1000 Hardware Manual

PTX1000 Packet Transport Router Hardware Guide
See Also

PTX1000 Installation Safety Guidelines

66
Connect the PTX1000 to a management console for initial configuration. See
5.
"Connecting the PTX1000 to a Management Console" on page
Initially configure Junos OS following the instructions in
6.
Configuration for the PTX1000" on page
PTX1000 Site Preparation Checklist on page 45
Observe the following guidelines before and during PTX1000 installation:
General Installation Safety Guidelines on page 66
PTX1000 Chassis Lifting Guidelines on page 66

General Installation Safety Guidelines

Before installing or moving the PTX1000, verify that the intended site meets the specified
power, environmental, and clearance requirements. See the following documentation:
PTX1000 Site Preparation Checklist on page 45
PTX1000 Clearance Requirements for Airflow and Hardware Maintenance on page 49
PTX1000 Rack Requirements on page 51
PTX1000 Environmental Requirements and Specifications on page 46
"PTX1000 AC Power Specifications" on page 40
on page 41

PTX1000 Chassis Lifting Guidelines

The weight of a fully-loaded PTX1000 is approximately 68.6 lb (31.1 kg) with AC power
supplies and 67.8 lb (30.8 kg) with DC power supplies installed. In addition to the
guidelines described in "Chassis and Component Lifting Guidelines" on page
the following guidelines for lifting and moving a PTX1000:
CAUTION: If you are installing the PTX1000 above 60 in. (152.4 cm) from
the floor, remove the power supplies and fan modules before attempting to
install the device. Unless you are using a mechanical lift, at least three persons
are required to perform the rack installation.
Before lifting or moving the PTX1000, disconnect all external cables.
When manually raising the PTX1000 into the rack, have two persons lift and align the
PTX1000 with the rack while another person secures the device to the rack. As when
lifting any heavy object, lift most of the weight with your legs rather than your back.
Keep your knees bent and your back relatively straight and avoid twisting your body
as you lift. Balance the load evenly and be sure that your footing is solid.
81.
"Performing the Initial Software
82.
or PTX1000 DC Power Specifications
Copyright © 2018, Juniper Networks, Inc.
118, observe