Subaru Legacy 2005 Service Manual page 1139

B: INSTALLATION
(1)
(1) Crankshaft bearing
(2) Crankshaft
1) Remove oil on the mating surface of bearing and
cylinder block before installation. Apply a coat of
engine oil to crankshaft pins.
2) Position the crankshaft on the #2 and #4 cylinder
block.
3) Apply liquid gasket to the mating surface of #1
and #3 cylinder block, and position it on #2 and #4
cylinder block.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
NOTE:
Do not allow liquid gasket to run over to O-ring
grooves, oil passages, bearing grooves, etc.
Cylinder Block
(4)
(3)
(3) Cylinder block
4) Apply a coat of engine oil to washers and bolt
threads.
5) Tighten the 10 mm cylinder block connecting
bolts on LH side (A — D) in alphabetical sequence.
Tightening torque:
10 N
ME-00145
ME(H4DOTC)-73
(3)
(2)
(4) Rear oil seal
⋅
m (1.0 kgf-m, 7.4 ft-lb)
(D)
(B)
MECHANICAL
ME-00144
(A)
(C)
ME-00840