Subaru Legacy 2005 Service Manual page 1035

26.Fuel Sub Level Sensor
A: REMOVAL
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel on the floor.
• Reduce the fuel in the fuel tank to less than 3/
4 beforehand. Be careful that fuel may spill
when the fuel is more than 3/4.
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle.
3) Set a container under the vehicle and remove
drain plug from fuel tank to drain fuel from fuel tank.
4) Tighten the fuel drain plug.
Tightening torque:
⋅
26 N m (2.65 kgf-m, 19.2 ft-lb)
5) Remove the rear seat.
6) Remove the service hole cover.
(1) Remove the bolts (A).
(2) Push the grommet (B) down and remove the
service hole cover.
(A)
Fuel Sub Level Sensor
IN-00203
FU-01123
(A)
(B)
FU-01126
FU(H4DOTC)-51
FUEL INJECTION (FUEL SYSTEMS)
7) Disconnect the connector from fuel sub level
sensor.
8) Disconnect the quick connector, and then dis-
connect the fuel delivery hose, return hose and jet
pump hose. <Ref. to FU(H4DOTC)-55, REMOVAL,
Fuel Delivery, Return and Evaporation Lines.>
9) Remove the bolts which install fuel sub level
sensor on the fuel tank.
(A)
(A) Jet pump hose
(B) Delivery hose
(C) Return hose
10) Remove the fuel sub level sensor.
FU-01143
(C)
(B)
FU-01144