Subaru Legacy 2005 Service Manual page 1146

MECHANICAL
(4) Install the oil pump to cylinder block. Be
careful not to damage the oil seal during instal-
lation.
Tightening torque:
⋅
6.4 N m (0.65 kgf-m, 4.7 ft-lb)
CAUTION:
• Do not forget to install the O-ring and seal
when installing oil pump.
• Align the flat surface of oil pump's inner rotor
with crankshaft before installation.
32) Install the water pump and gasket.
Tightening torque:
⋅
First: 12 N m (1.2 kgf-m, 8.9 ft-lb)
⋅
Second: 12 N m (1.2 kgf-m, 8.9 ft-lb)
CAUTION:
• Be sure to use a new gasket.
• When installing the water pump, tighten the
bolts in two stages in alphabetical sequence as
shown in the figure.
(C)
(D)
(E)
33) Install the water by-pass pipe for heater.
Cylinder Block
(B)
(A)
(F)
ME-02463
ME(H4DOTC)-80
34) Install the oil cooler. (MT model)
Tightening torque:
⋅
T1: 54 N m (5.5 kgf-m, 39.8 ft-lb)
⋅
T2: 69 N m (7.0 kgf-m, 50.9 ft-lb)
T2
(A)
(B)
T1
(C)
(A) O-ring
(B) Oil cooler
(C) Oil cooler connector
35) Install the oil filter.
36) Install the water by-pass pipe between oil cool-
er and water pump.
37) Install the water pipe.
NOTE:
Always use new O-rings.
38) Install the cylinder head.
<Ref. to ME(H4DOTC)-62, INSTALLATION, Cylin-
der Head.>
39) Install the oil level gauge guide. (LH side)
40) Install the rocker cover.
41) Install the crank
ME(H4DOTC)-55, INSTALLATION, Crank Sprock-
et.>
42) Install the cam sprocket.
<Ref. to ME(H4DOTC)-54, INSTALLATION, Cam
Sprocket.>
43) Install the timing belt.
<Ref. to ME(H4DOTC)-48, INSTALLATION, Tim-
ing Belt.>
44) Install the timing belt cover.
<Ref. to ME(H4DOTC)-45, INSTALLATION, Tim-
ing Belt Cover.>
ME-00723
sprocket. <Ref. to