Subaru Legacy 2005 Service Manual page 1110

MECHANICAL
2. MT MODEL
1) Install the crank pulley.
2) Install the pulley bolt.
To lock the crankshaft, use the ST.
ST 499977100 CRANK PULLEY WRENCH
(1) Clean the crank pully thread using com-
pressed air.
(2) Apply engine oil to the crank pulley bolt seat
and thread.
(3) Tighten the bolt temporarily with tightening
torque of 44 N⋅m (4.5 kgf-m, 33 ft-lb).
(4) Tighten the crank pulley bolts.
Tightening torque:
⋅
180 N m (18.4 kgf-m, 132.8 ft-lb)
ST
3) Confirm that the tightening angle of the crank
pulley bolt is 65° or more. Perform the following
procedures when less than 65°.
CAUTION:
If the tightening angle of crank pulley bolt is
less than 65°, the bolt should be damaged. In
this case, the bolt must be replaced.
(1) Replace the crank pulley bolts and clean
them.
Crank pulley bolt:
Part No. 12369AA011
(2) Clean the crank pulley thread using com-
pressed air.
(3) Apply engine oil to the crank pulley bolt seat
and thread.
(4) Tighten the bolt temporarily with tightening
torque of 44 N⋅m (4.5 kgf-m, 33 ft-lb).
(5) Tighten the crank pulley bolts keeping them
in an angle between 65° — 75°.
NOTE:
Perform the tightening procedures by confirming
the turning angle of crank pulley bolt referring to the
gauge of timing belt cover.
Crank Pulley
4) Install the A/C belt tensioner.
5) Install the V-belts. <Ref. to ME(H4DOTC)-40,
INSTALLATION, V-belt.>
C: INSPECTION
1) Check the V-belt is not worn or otherwise dam-
aged.
2) Check the tension of the belt. <Ref. to
ME(H4DOTC)-41, INSPECTION, V-belt.>
ME-00063
ME(H4DOTC)-44
ME-00061