Subaru Legacy 2005 Service Manual page 1098

MECHANICAL
(2) Engine ground terminals
(3) Generator connector, terminal and A/C
compressor connector
(B)
(A) A/C compressor connector
(B) Generator connector and terminal
13) Disconnect the following hoses:
(1) Brake booster vacuum hose
(2) Heater inlet and outlet hoses
(3) Remove the hose between intake manifold
(A) and pressure regulator (B).
(A)
Engine Assembly
ME-00028
(A)
ME-00804
FU-01161
(B)
ME-00846
ME(H4DOTC)-32
14) Remove the power steering pump from brack-
et.
(1) Loosen the lock bolt and slider bolt, and re-
move the front side belt. <Ref. to ME(H4DOTC)-
40, FRONT SIDE BELT, REMOVAL, V-belt.>
(2) Disconnect the power steering switch con-
nector.
(3) Remove the power steering pump from en-
gine.
(4) Place the power steering pump onto right
side wheel apron.
15) Remove the linear motion mounting. <Ref. to
ME(H4DOTC)-38, REMOVAL,
Mounting.>
16) Lift-up the vehicle.
17) Remove the center exhaust pipe.
<Ref. to EX(H4DOTC)-6, REMOVAL, Center Ex-
haust Pipe.>
ME-00035
ME-00809
Linear Motion