Subaru Legacy 2005 Service Manual page 1137

24) Remove the service hole cover and service
hole plugs using a hexagon wrench [14 mm].
25) Rotate the crankshaft to bring #1 and #2 pis-
tons to bottom dead center position, then remove
the piston snap ring through service hole of #1 and
#2 cylinders.
26) Draw out the piston pins from #1 and #2 pistons
using ST.
ST 499097600 PISTON PIN REMOVER
ASSY (MT MODEL)
ST 499097700 PISTON PIN REMOVER
ASSY (EXCEPT FOR MT
MODEL)
NOTE:
Be careful not to confuse the original combination
of piston, piston pin and cylinder.
27) Similarly remove the piston pins from #3 and #4
pistons.
28) Remove the bolts which connect cylinder block
on the side of #2 and #4 cylinders.
Cylinder Block
ME-00140
ME-00141
ST
ME-00142
ME(H4DOTC)-71
29) Loosen the bolts which connect cylinder block
on the side of #1 and #3 cylinders for two or three
turns.
30) Place the cylinder block to face the #1 and #3
cylinder side upward, and remove cylinder block
connecting bolts.
MECHANICAL