Subaru Legacy 2005 Service Manual page 1032

FUEL INJECTION (FUEL SYSTEMS)
24.Fuel Pump
A: REMOVAL
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel on the floor.
• Reduce the fuel in the fuel tank to less than 3/
4 beforehand. Be careful that fuel may spill
when the fuel is more than 3/4.
NOTE:
Fuel pump assembly consists of fuel pump and fuel
level sensor.
1) Release the fuel pressure.
<Ref. to FU(H4DOTC)-39, RELEASING OF FUEL
PRESSURE, PROCEDURE, Fuel.>
2) Open the fuel filler flap lid, and remove the fuel
filler cap.
3) Disconnect the ground cable from battery.
4) Lift-up the vehicle.
5) Remove the fuel tank protector.
6) Set a container under the vehicle and remove
drain plug from fuel tank to drain fuel from fuel tank.
7) Tighten the fuel drain plug.
NOTE:
Use a new gasket.
Tightening torque:
⋅
26 N m (2.65 kgf-m, 19.2 ft-lb)
8) Remove the rear seat.
Fuel Pump
9) Remove the service hole cover.
(1) Remove the bolts (A).
(2) Push the grommet (B) down and remove
service hole cover.
10) Disconnect the connector from fuel pump.
11) Disconnect the quick connector and then dis-
connect the fuel delivery hose, return hose and jet
IN-00203
pump hose. <Ref. to FU(H4DOTC)-55, REMOVAL,
Fuel Delivery, Return and Evaporation Lines.>
12) Remove the nuts which install fuel pump as-
sembly onto fuel tank.
FU-01123
13) Remove the fuel pump assembly from fuel
tank.
FU(H4DOTC)-48
(A)
(B)
(B)
(A)
(A) Delivery hose
(B) Return hose
(C) Jet pump hose
(A)
FU-01124
FU-01125
(C)
FU-01140