MECHANICAL
31) Separate the cylinder block (LH) and (RH).
NOTE:
When separating the cylinder block, do not allow the connecting rod to fall and damage the cylinder block.
(5)
(1)
Cylinder block
(2)
Rear oil seal
32) Remove the rear oil seal.
33) Remove the crankshaft together with connect-
ing rod.
34) Remove the crankshaft bearings from cylinder
block using a hammer handle.
NOTE:
Do not confuse the combination of crankshaft bear-
ings. Press the bearing at the end opposite to lock-
ing lip.
35) Draw out each piston from cylinder block using
a wooden bar or hammer handle.
NOTE:
Be careful not to confuse the original combination
of piston and cylinder.
Cylinder Block
(1)
(4)
(3)
(3)
Crankshaft
(4)
Crankshaft bearing
ME(H4DOTC)-72
(2)
(4)
(1)
(5)
(5)
Piston
ME-00143