Table of Contents
Advertisement
MECHANICAL
2) Camshaft cap and oil flow control solenoid valve
assembly installation:
(1) Apply small amount of liquid gasket to the
cap mating surface.
NOTE:
Do not apply liquid gasket excessively. Otherwise,
the excessive liquid gasket may come out and flow
toward oil seal, resulting in oil leaks.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
(2) Apply engine oil to the cap bearing surface,
and install the cap on camshaft as shown by
identification mark.
(3) Gradually tighten the camshaft cap and oil
control valve assembly in at least two stages in
alphabetical sequence shown in the figure, and
then tighten to the specified torque.
Tightening torque:
⋅
T1: 20 N
m (2.0 kgf-m, 14.8 ft-lb)
⋅
T2: 9.75 N
m (1.0 kgf-m, 7.2 ft-lb)
(G)
(C)
T2
(E)
(A)
(F)
(B)
T2
(D)
(H)
(4) After tightening the camshaft cap, ensure
the camshaft rotates only slightly while holding it
at "base circle".
Camshaft
ME-00773
(L)
T1
(K)
(J)
T1
(I)
ME-00839
ME(H4DOTC)-58
3) Install the camshaft position sensor on exhaust
side.
Tightening torque:
⋅
6.4 N
m (0.65 kgf-m, 4.7 ft-lb)
4) Camshaft oil seal installation:
Apply grease to the new oil seal lips and press onto
the front end of camshaft by using ST1 and ST2.
NOTE:
Use a new oil seal.
ST1 499587600
OIL SEAL INSTALLER
ST2 499597200
OIL SEAL GUIDE
ST1
FU-01186
ST2
ME-00116
Advertisement
Chapters
Table of Contents
