3) Installation of timing belt:
Align the alignment marks on the timing belt with marks on the sprockets in the alphabetical order shown in
the figure. While aligning marks, position the timing belt properly.
CAUTION:
• Disengagement of more than one timing belt tooth may result in interference between valve and
piston.
• Ensure the belt's rotating direction is correct.
(3)
RH-IN
RH-EX
(E)
(1)
Arrow mark
(2)
Timing belt
(3)
28 tooth length
4) Install the belt idlers.
Tightening torque:
⋅
39 N
m (4.0 kgf-m, 28.8 ft-lb)
NOTE:
Make sure that the marks on the timing belt and
sprockets are aligned.
5) After ensuring that the marks on the timing belt
and sprockets are aligned, remove the stopper pin
from tensioner adjuster.
Timing Belt
(1)
(4)
(D)
(7)
(4)
54.5 tooth length
(5)
51 tooth length
(6)
28 tooth length
ME-00090
ME(H4DOTC)-51
(5)
(B)
(A)
(7)
Install it in the end.
MECHANICAL
(2)
(6)
LH-IN
LH-EX
(C)
ME-00089