MECHANICAL
13.V-belt
A: REMOVAL
NOTE:
Perform the following procedures with the engine
installed to the body.
1. FRONT SIDE BELT
1) Remove the collector cover.
2) Remove the V-belt covers.
3) Loosen the lock bolt (A).
4) Loosen the slider bolt (B).
5) Remove the front side belt (C).
(B)
2. REAR SIDE BELT
1) Loosen the lock nut (A).
2) Loosen the slider bolt (B).
3) Remove the A/C belt.
V-belt
ME-00807
(C)
(A)
ME-00059
(B)
(A)
ME-00060
ME(H4DOTC)-40
4) Remove the A/C belt tensioner.
B: INSTALLATION
NOTE:
Wipe off any oil or water on the belt and pulley.
1. FRONT SIDE BELT
1) Install the V-belt (C), and tighten the slider bolt
so as to obtain the specified belt tension. <Ref. to
ME(H4DOTC)-41, INSPECTION, V-belt.>
2) Tighten the lock bolt (A).
3) Tighten the slider bolt (B).
Tightening torque:
Lock bolt (A)
⋅
25 N
m (2.5 kgf-m, 18.4 ft-lb)
Slider bolt (B)
⋅
8 N
m (0.8 kgf-m, 5.8 ft-lb)
(B)
ME-00061
(C)
(A)
ME-00059