Subaru Legacy 2005 Service Manual page 1115

2. TIMING BELT
1) Preparation for installation of automatic belt ten-
sion adjuster assembly <Ref. to ME(H4DOTC)-48,
AUTOMATIC BELT TENSION ADJUSTER AS-
SEMBLY AND BELT IDLER, INSTALLATION,
Timing Belt.>
2) Crankshaft and cam sprocket alignment
(1) Align the mark (A) on crank sprocket with
the mark on oil pump cover at cylinder block.
(A)
(2) Align single line mark (A) on the exhaust
cam sprocket (RH) with the notch (B) on timing
belt cover.
(A)
(B)
(3) Align single line mark (A) on the intake cam
sprocket (RH) with the notch (B) on timing belt
cover. (Ensure double lines (C) on intake and
exhaust cam sprockets are aligned.)
(B)
(A)
(C)
Timing Belt
(4) Align single line mark (A) on exhaust cam
sprocket (LH) with notch (B) on timing belt cover
by turning the sprocket counterclockwise (as
viewed from front of engine).
(5) Align single line mark (A) on intake cam
sprocket (LH) with notch (B) on timing belt cover
by turning the sprocket clockwise (as viewed
from front of engine). Ensure double lines (C) on
intake and exhaust cam sprockets are aligned.
ME-00081
ME-00082
ME-00083
ME(H4DOTC)-49
MECHANICAL
(B)
(A)
ME-00084
(B)
(A)
(C)
ME-00085