Toyota Avensis ZZT251 2003 Service And Repair Manual page 1404

60–44
SUPPLEMENTAL RESTRAINT SYSTEM
Stripped Wire Harness Section
Width
Inner
Diam.
SST(s)
AVENSIS REPAIR MANUAL (RM1018E)
(d)
Wire Harness
Diameter
CAUTION:
If a wire harness which is too thin or an alternative object
is used to tie down the curtain shield airbag assy LH, it may
be snapped by the shock when the airbag is deployed. Al-
ways use a wire harness for vehicle use which has a diame-
H40008
ter of at least 1.25 mm
HINT:
Y
Y
H42761
CAUTION:
Y
NOTICE:
The tire will be marked by the airbag deployment, so use a
redundant tire.
(e)
H42792
http://vnx.su
– CURTAIN SHIELD AIR BAG ASSY LH
Using a service–purpose wire harness for the vehicle, tie
down the curtain shield airbag assy LH to the tire.
Wire harness: Stripped wire harness section
2
1.25 mm or more (0.0019 in.
2
(0.0019 in.
To calculate the square of the stripped wire harness sec-
tion:
Square = 3.14 x (Diameter)
Position the curtain shield airbag assy LH inside the tire
as shown in the illustration.
Tire size: Must exceed the following dimensions
Width: 185 mm (7.28 in.)
Inner diameter: 360 mm (14.17 in.)
Make sure that the wire harness is tight. It is highly
dangerous when looseness in the wire harness re-
sults in the curtain shield airbag assy LH coming free
due to the shock from the airbag deployment.
Install the SST(s).
Connect the connectors of the SST(s) to the curtain shield
airbag assy LH.
SST 09082–00802 (09082–10801, 09082–20801)
2
or more)
2
).
2
divided by 4