SUPPLEMENTAL RESTRAINT SYSTEM
SST(s)
SST(s)
SST(s)
Battery
10 m (33 ft) or more
AVENSIS REPAIR MANUAL (RM1018E)
(f)
Place the tires.
CAUTION:
Do not place the deployment direction of the curtain shield
airbag assy LH facing toward the ground.
Tires
(1)
(5 or more)
(2)
H42762
NOTICE:
Do not place the SST(s) connector under the tire because
the SST connector could be damaged.
(3)
CAUTION:
Make sure that the wire harness is tight. It is highly danger-
ous when looseness in the wire harness results in the tires
coming free due to the shock from the airbag deployment.
HINT:
Place the SST(s) connector and the wire harness inside tires.
Secure at least 1 m (3 ft) of slack for the wire harness.
H42763
(g)
Install the SST(s).
Connect one SST(s) connector to the SST(s) connector
connected to the curtain shield airbag.
SST
NOTICE:
To avoid damaging the SST(s) connector and wire harness,
do not lock the secondary lock of the twin lock. Also, se-
cure some slack for the SST(s) wire harness inside the tire.
(h)
Deploy the airbag.
H42764
(1)
(2)
(3)
HINT:
The airbag deploys as the LED of the SST(s) activation switch
comes on.
http://vnx.su
–
CURTAIN SHIELD AIR BAG ASSY LH
Place at least 2 tires under the tire to which the cur-
tain shield airbag assy LH is tied.
Place at least 2 tires over the tire to which the curtain
shield airbag assy is tied. The top tire should have
the wheel installed.
Tie the tires together with 2 wire harnesses.
09082–00700
Connect the red clip of the SST(s) to the battery
positive (+) terminal and the black clip of the SST(s)
to the battery negative (–) terminal.
Check that no one is within a 10 m (33 ft) radius of
the tire to which the curtain shield airbag assy LH is
tied.
Press the activation switch of the SST(s) and
deploy the airbag.
60–45