Toyota Avensis ZZT251 2003 Service And Repair Manual page 1367

55–70
REPLACEMENT
1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
SST 07110–58060 (07117–58080, 07117–58090, 07117–78050, 07117–88060, 07117–88070,
07117–88080)
4. REMOVE RADIATOR SUPPORT OPENING COVER
5. REMOVE ENGINE ROOM COVER SIDE
6. REMOVE ENGINE UNDER COVER SUB–ASSY NO.1
7. REMOVE FAN AND GENERATOR V BELT
9. INSPECT COMPRESSOR OIL
(a) When replacing the w/pulley compressor assy with a new one, after gradually removing the refrigerant
gas from the service valve, drain the following amount of oil from the new w/pulley compressor assy
before installation.
Standard:
(Oil capacity inside new w/pulley compressor assy: 90 + 15 cc (3.0 + 0.5 fl. oz.) ) – (Remaining
oil amount in the removed w/pulley compressor assy) = (Oil amount to be removed when replac-
ing)
AVENSIS REPAIR MANUAL (RM1018E)
HEATER & AIR CONDITIONER
2. DISCONNECT COOLER REFRIGERANT SUCTION
HOSE NO.1
(a) Remove the bolt and disconnect the cooler refrigerant
suction hose No.1 from the w/pulley compressor assy.
(b) Remove the O–ring from the cooler refrigerant suction
hose No.1.
NOTICE:
Seal the opening of the disconnected parts using vinyl tape
to prevent moisture and foreign matters from entering.
I35323
3. DISCONNECT COOLER REFRIGERANT DISCHARGE
HOSE NO.1
(a) Remove the bolt and disconnect the cooler refrigerant
discharge hose No.1 from the w/pulley compressor assy.
(b) Remove the O–ring from the cooler refrigerant discharge
hose No.1.
NOTICE:
Seal the opening of the disconnected parts using vinyl tape
to prevent moisture and foreign matters from entering.
I35324
(See page
8. REMOVE W/PULLEY COMPRESSOR ASSY
(a) Disconnect the connector.
(b) Remove the 3 bolts and the w/pulley compressor assy.
I35325
http://vnx.su
– W/PULLEY COMPRESSOR ASSY (3ZZ–FE)
(See page 14–5)
14–5)
(See page 14–5)
(See page 14–5)
(See page 55–38)
550YY–01