Ricoh M022 Service Manual page 52

2. Installation
Settings Relevant to the Service Contract
Change the necessary settings for the following SP modes if the customer has made a service contract.
• You must select one of the counter methods (developments/prints) in accordance with the contract
(SP5045-001).
2
Counting method
SP No.
SP5-045-001
Service Tel. No. Setting
SP No.
SP5-812-001
through 004
Settings for @Remote Service
• Prepare and check the following check points before you visit the customer site. For details, ask the
@Remote key person.
Check points before making @Remote settings
1. The setting of SP5816-201 in the mainframe must be "0".
2. Print the SMC with SP5990-002 and then check if a device ID2 (SP5811-003) must be correctly
programmed.
• 6 spaces must be put between the 3-digit prefix and the following 8-digit number (e.g.
xxx______xxxxxxxx).
• ID2 (SP5811-003) and the serial number (SP5811-001) must be the same (e.g. ID2:
A01______23456789 = serial No. A0123456789)
3. The following settings must be correctly programmed.
• Proxy server IP address (SP5816-063)
• Proxy server Port number (SP5816-064)
50
CÓPIA NÃO CONTROLADA
Function
Specifies if the counting method used in meter charge
mode is based on developments or prints.
NOTE: You can set this one time only. You cannot
change the setting after you have set it for the first time.
Function
5812-002 programs the service station fax number.
The number is printed on the counter list when the
meter charge mode is selected. This lets the user fax
the counter data to the service station.
CÓPIA NÃO CONTROLADA
Default
"0": Developments
Default