Ricoh M022 Service Manual page 191

1. Plug in and turn on the main power switch.
2. Check that the settings of SP2-119-001, -002 and -003 are "0". If these settings are not "0", execute
"Recovery procedure for no replacement preparation of laser unit" described above.
• If this step is not correctly done, an image problem may occur on printouts.
3. Input the SP settings on the sheet provided with a new laser unit.
• SP2-101-001: Color Registration Adjustment for Black
• SP2-102-013, 015, 017, 019: Magnification Adjustment Main Beam Pitch Dot for each color
• SP2-102-014, 016, 018, 020: Magnification Adjustment Main Beam Pitch Subdot for each
color
• SP2-102-001: Main Magnification for Black and Standard line speed
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA
Laser Optics
4
189