Ricoh M022 Service Manual page 779

P-Roll Thresh AF Ready
005
Specifies the threshold temperature of the pressure roller for entering the wait time mode
(SP1-113-001).
P-Roll Thresh AF Job
006
Specifies the threshold temperature of the pressure roller for entering the wait time mode
(SP1-113-004).
On/Off SW Timer
008
Specifies the interval for entering the PID control from the On/Off control.
1115 [Stand-by Idling]
Interval
001
Specifies the interval between idling during stand-by mode.
This idling during the stand-by mode prevents the roller deformation.
Idling Time
002
Specifies the length of each idling operation during stand-by mode.
003 Idling Speed
[Fusing Temp Change]
1116
Paper Type –> MThick: Middle Thick
Center Temp. 1
Specifies the temperature correction for the heating roller (center) when the paper width is
010
226 mm or more.
The start time of this SP can be adjusted with SP1116-018.
Ends Temp. 1
Specifies the temperature correction for the heating roller (ends) when the paper width is
011
226 mm or more.
The start time of this SP can be adjusted with SP1116-018.
CÓPIA NÃO CONTROLADA
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
ENG
ENG
CÓPIA NÃO CONTROLADA
[0 to 160 / 120 / 1 deg/step]
[0 to 160 / 100 / 1 deg/step]
[0 to 999 / 300 / 1 sec/step]
[0 to 240 / 60 / 1 min/step]
[0 to 60 / 2 / 0.1 sec/step]
[0 to 1 / 0 / 1 mm/sec/step]
[-10 / 10 / 0 / 1 deg/step]
[-10 to 10 / 0 / 1 deg/step]
System SP-xxx
3
33