Ricoh M022 Service Manual page 185

• Do not attach the pulley on the shaft with the screw at this time.
5. Install the wire.
• The winding of the wire on the three pulleys at the rear of the scanner should be the same as the
winding on the three pulleys at the front. This must show as a mirror image.
Example: At the front of the machine, the side of the drive pulley with the three windings must face the
front of the machine. At the rear of the machine, it must face the rear.
6. Do steps 7 through 13 again in the "Front Scanner Wire" Section.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA
Scanner Unit
4
183