Ricoh M022 Service Manual page 769

012 Offset: Feed Start: M-Thick
013 Offset: Feed Start: 600dpi: Plain1: BW
014 Offset: Feed Start: 600dpi: Plain2: BW
030 Offset: Feed Start: Time
031 Offset:Feed Start:1200dpi
033 Offset: Feed Start: Glossy
1105 [Fusing Temperature] Fusing Temperature Adjustment
(Printing Mode, Roller Type, [Color], Simplex/Duplex)
Roller Type –> Center and Ends: Heating roller, P-Roller –> Pressure roller
Paper Type -> Plain, Thin, Thick, OHP, Middle Thick, Special
Fusing Ready Temp
001
Specifies the heating roller target temperature for the ready condition.
002 Fusing Ready: Offset
003 P-Roll Ready Target Temp.
P-Roll Ready Temp
Sets the heating roller offset temperature at the end of the heating roller. This value is one of
007
the thresholds to determine if the machine is at the heating roller target temperature during
warm-up.
010 Stand-By: Center
011 Stand-By: Ends
Stand-By:P-Roller
012
Sets the pressure roller offset temperature. This value is one of the thresholds to determine if
the machine is at the heating roller target temperature during warm-up.
Panel Off Mode: Center
013
Specifies the heating roller temperature (center) in the panel off mode.
Panel Off Mode: Ends
014
Specifies the heating roller temperature (both ends) in the panel off mode.
CÓPIA NÃO CONTROLADA
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
* ENG
* ENG
* ENG
* ENG
* ENG
CÓPIA NÃO CONTROLADA
[0 to 100 / 10/ 1 deg/step]
[0 to 100 / 25/ 1 deg/step]
[0 to 100 / 25/ 1 deg/step]
[15 to 500 / 60 / 1 sec/step]
[0 to 100 / 15 / 1 deg/step]
[0 to 100 / 15/ 1 deg/step]
[100 to 180 / 160 / 1 deg/step]
[5 to 30 / 11 / 1 deg/step]
[50 to 160 / 120 / 1 deg/step]
[0 to 150 / 20 / 1 deg/step]
[50 to 180 / 160 / 1 deg/step]
[50 to 180 / 160 / 1 deg/step]
[50 to 160 / 140 / 1 deg/step]
[50 to 180 / 140 / 1 deg /step]
[50 to 180 / 140 / 1 deg /step]
System SP-xxx
3
23