Ricoh M022 Service Manual page 182

4. Replacement and Adjustment
4
7. Remove the tape from the drive pulley.
8. Insert a scanner-positioning pin [A] through the 2 nd carriage hole [B] and the left holes [C] in the
front rail. Insert another scanner positioning pin [D] through the 1 st carriage hole [E] and the right
holes in the front rail [F].
9. Insert two more scanner positioning pins through the holes in the rear rail.
10. Install the white clip [G] and drive pulley to the shaft [H] ( x 1).
11. Screw the scanner wire bracket to the front rail [I].
12. Screw the scanner wire holder [J].
13. Pull out the positioning pins.
• Make sure the 1st and 2nd carriages move smoothly after you remove the positioning pins. Do
steps 8 through 13 again if they do not.
180
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA