Ricoh M022 Service Manual page 950

3. Appendix: SP Mode Tables
003 Day
004 Hour
005 Minute
[Environmental Displ: Job End]
3514
Displays the environmental conditions at the last job.
3
These are used for process control execution timing.
001 Temperature
002 Relative Humidity
003 Absolute Humidity
[Execution Interval: Display]
Displays the current interval for process control execution.
3515
When the machine calculates the timing for process control, it uses a number of conditions.
These are the results after considering all the conditions.
001 Job End: Process Control: BW
002 Job End: Process Control: FC
003 Interrupt: Process Control: BW
004 Interrupt: Process Control: FC
[Refresh Mode] DFU
While making prints with low coverage, the developer is agitated with less toner consumption
3516
and the toner carrier attraction tends to increase. This may cause low image density or poor
transfer (white dots). To prevent this, the coagulated toner or overcharged toner has to be
consumed by performing the refresh mode.
001 Dev. Motor Rotation: Display: Bk
002 Dev. Motor Rotation: Display: C
003 Dev. Motor Rotation: Display: M
004 Dev. Motor Rotation: Display: Y
204
CÓPIA NÃO CONTROLADA
*ENG [1 to 31 / 1 / 1/step]
*ENG [0 to 23 / 0 / 1/step]
*ENG [0 to 59 / 0 / 1/step]
*ENG [-1280 to 1270 / 0 / 0.1°C/step]
*ENG [0 to 1000 / - / 0.1%RH/step]
*ENG [0 to 1000 / - / 0.1 g/cm
*ENG
*ENG
*ENG
*ENG
CÓPIA NÃO CONTROLADA
3
[0 to 2000 / 500 / 1 page/step]
[0 to 2000 / 200 / 1 page/step]
[0 to 2000 / 500 / 1 page/step]
[0 to 2000 / 200 / 1 page/step]
*ENG
*ENG
[0 to 1000 / 0 / 0.1 m/step]
*ENG
*ENG
/step]